Auto Switch D
|Solid state auto switch
|General purpose type
2-color indicator with diagnostic output
Water resistant 2-color indicator
|Reed auto switch
|General purpose type 2-color indicator
Analog Auto Switch and Display Sensor Monitor D-MH1□
・Outputs the analog voltage according to the actuator stroke position
・A single switch can discriminate between max. 3 position points.
Discriminable resolution: ±0.1 mm ∗ Within the high-resolution range
・Detection position setting can be done away from the actuator.
・Analog voltage output (1 to 5 V)
・Can also be used with the analog auto switch single unit
・Reduced setting labor
・No need to fine-tune the switch mounting position
・Easy adjustment even in narrow places and on moving parts
・Gripper fully open → gripping → gripping failure detection
・Detection of gripper finger wear
・Minimized lead wire disconnection risk
|Analog auto switch
|Analog output sensor (1 to 5 V)
|Display sensor monitor, NPN 2 outputs
|Display sensor monitor, PNP 2 outputs
Trimmer Auto Switch D
・Easily distinguish workpieces with a single auto switch
・Minimum detectable adjustment width: 0.5 mm
・Applicable to the short stroke cylinder
The detection of the extended and retracted end positions can be made by a single auto switch.
This switch can be used when two auto switches cannot be mounted due to a short stroke.
|Direct mounting (Round groove)
|Direct mounting (Square groove)