Cylinder Series 25A-CQ2 Cylinder Series 25A-MXQ Solenoid Valve Series 25A-SY Cylinder Series 25A-CA2 Cylinder Series 25A-MGPM Air Gripper Series 25A-MHZ �祐ervice life and performance have been improved at a low dew point. �誘sing grease compatible with a low dew point. Low dew point Series 25A- .70°C Compatible with .70°C (Refer to page 10 for part numbers of the maintenance grease pack.) Bushing Material: Steel bearing alloy Tie-rod Material: Stainless steel Mounting bracket Surface treatment: RAYDENTR Cushion valve Material: Stainless steel Mounting bolt Material: Stainless steel Fittings Metal parts material: Stainless steel Bushing (o50 to o100) Material: Steel bearing alloy Piston rod Surface treatment: Hard chrome plating Mounting bracket Surface treatment: RAYDENTR .1 Coils for solenoid valves, connector pins, and lead wires are made of copper. .2 Manifold terminal block, wiring parts, connector metal parts and printed circuit board are made of copper. Cover holding screw Material: Stainless steel Bushing (o50 to o100) Material: Steel bearing alloy Piston rod Surface treatment: Hard chrome plating Plate Surface treatment: Electroless nickel plating Bolts Surface treatment: Electroless nickel plating Piston rod Surface treatment: Electroless nickel plating Piston Material: Stainless steel Aluminum alloy Bolts Surface treatment: Electroless nickel plating �勇lectrolytic nickel plating with a copper layer (Electroless nickel plating is used) . Zinc plating Copper (Cu) Zinc (Zn) Not Used Material Surface Treatment 1