End plate Hook (1) (2) (2) (1) (a) (a) (b) �� Trademark DeviceNet. is a trademark of ODVA. CompoNet. is a trademark of ODVA. Element Part No. Type Element part no. VQ1000 VVQ1000-82A-1 VQ2000 VVQ2000-82A-1 Built-in silencer, direct exhaust The minimum order quantity is 10 pcs. IP65 Enclosure Caution Wiring connection for models conforming to IP65 should also have enclosures equivalent to or of stricter than IP65. How to Calculate Flow Rate Refer to front matters 42 to 45 for obtaining the flow rate. How to Mount/Remove DIN Rail Built-in Silencer Element Caution Caution Removing 1. Loosen the clamp screw on side (a) of the end plate on both sides. 2. Lift side (a) of the manifold base and slide the end plate in the direction of (2) shown in the figure to remove. Mounting 1. Hook side (b) of the manifold base on the DIN rail. 2. Press down side (a) and mount the end plate on the DIN rail. Tighten the clamp screw on side (a) of the end plate. The proper tightening torque for screws is 0.4 to 0.6 N・m. A filter element is incorporated in the end plate on both sides of the maifold base. A dirty and choked element may reduce cylinder speed or cause malfunction. Clean or replace the dirty element. Remove the cover from the top of the end plate and remove the old element with a flat head screwdriver, etc. Series VQ1000/2000 Specific Product Precautions 3 Be sure to read before handling. Refer to front matter 53 for Safety Instructions and pages 3 to 8 for 3/4/5 Port Solenoid Valve Precautions. 1063 SY SJ SY SV SYJ SZ VF VP4 S0700 VQ VQ4 VQ5 VQC VQC4 VQZ SQ VFS VFR VQ7