Convex part Socket housing Junction cover Round type terminal Tightening torque: 0.25 to 0.35 N・m 2A 3A 4A 13A 1B 2B 3B 4B 5B 6B 7B 8B 9B 10B 11B 12B 13B 5A 6A 7A 8A 9A 12A 11A 10A Convex part 1A Red Terminal no. White Black How to Add Manifold Stations (Plug-in Type/Lead Wire Connection Type) What to order �� Manifold block assembly (Refer to the above !7.) Steps for adding stations q Loosen hexagon bolts from the end plate at the U-side and remove the end plate. w Connect the tie rod for increasing the station number, open the junction cover, mount the manifold block assembly and U-side end plate and tighten them by hexagon bolts. (Tightening torque: 0.85 to 0.95 N・m) e Connect the round type terminal of red lead wire to the common terminal inside the junction cover. r Take out the socket housing and connect the black and white lead wires. The connection layout is common to all kits. Tie-rod for station additions U-side end plate Hexagon bolt Tightening torque: 0.85 to 0.95 N・m Red COM. Black Station 1 SOL.A Black Station 3 SOL.A Black Station 4 SOL.A Black Station 5 SOL.A Black Station 6 SOL.A COM. Red SOL.A Station 2 Black SOL.B Station 3 White SOL.B Station 4 White SOL.B Station 5 White Series S0700 958