Warning Push down on the manual override button with a small screwdriver until it stops. Note) In order not to damage the connector and cover, do not pull the lead wire excessively (with a force of 10 N or more). Push type (Tool required) To attach a connector, hold the lever and connector unit between your fingers and insert straight onto the pins of the solenoid valve so that the lever’s pawl is pushed into the groove and locks. To detach a connector, remove the pawl from the groove by pushing the lever downward with your thumb, and pull the connector straight out. Caution Proper tightening torque N・m 0.17 to 0.23 Tighten the bolts firmly to stop the gasket from coming away from the valve using the appropriate torque as shown on the following table. Mounting screw (M2) Mounting screw (M2) Connector Lever Cover Lever pawl Groove Plug-in Plug-in Plug lead Plug lead Manual Override How to Attach/Detach Plug Connector How to Mount Valve Bore o3.2 Bore o3.2 Series S0700 Specific Product Precautions 1 Be sure to read before handling. Refer to front matter 53 for Safety Instructions, Pages 3 to 8 for 3/4/5 Port Solenoid Valve Precautions. The manual override is used for switching the main valve. 973 SY SJ SY SV SYJ SZ VF VP4 S0700 VQ VQ4 VQ5 VQC VQC4 VQZ SQ VFS VFR VQ7