q w e r t y Type 60 (Non plug-in) manifold (1) Loosen one DIN rail holding screw on either U side or D side. (2) Separate the blocks at the location where station expansion is desired. (3) Mount the valve on the DIN rail. (4) While pressing the manifold together from both sides, retighten the DIN rail holding screw of the end block assembly which was loosened. 2 3 4 5 6 End block assembly End block assembly SUP block bush assembly SUP block bush assembly DIN rail Part no. Note Refer to page 766. D side U side C6: With One-touch fitting for o6 C8: With One-touch fitting for o8 L6: With One-touch fitting for o6 (Elbow fetching upward) L8: With One-touch fitting for o8 (Elbow fetching upward) B6: With One-touch fitting for o6 (Elbow fetching downward) B8: With One-touch fitting for o8 (Elbow fetching downward) No. Description Component Parts SZ3000-53-8A SZ3000-53-7A SZ3000-114-3A SZ3000-114-1A VZ1000-11-1-�ｭ 1 SUP/EXH block assembly SZ3000-50-2A-�ｭ�ｭ Caution Caution (Tightening torque: 1.4 N・m) Manifold Station Expansion Station expansion is possible at any position. DIN rail holding screw U side D side DIN rail holding screw 1. Be sure to shut off the power and air supplies before disassembly. Furthermore, since air may remain inside the actuator, piping and manifold, confirm that the air is completely exhausted before performing any work. 2. When disassembly and assembly are performed, air leakage may result if connections between blocks and tightening of the end block’s holding screw, is inadequate. Before supplying air, confirm that there are no gaps, etc. between blocks, and that manifold blocks are securely fastened to the DIN rail. Then supply air and confirm that there is no air leakage before operating. 782 Series SZ3000 Manifold Exploded View