(1) (2) (3) (4) Take out the receptacle housing for expansion which is inside the SUP/EXH block, attach it to the newly added housing holder, and attach to the manifold. (Numbers are displayed on the side of the receptacle housings, and they should be used in order from the lowest number.) Loosen the DIN rail holding screw if the end block on the U side. Separate the end block and SUP/EXH block. Mount the valve on the DIN rail. Press the manifold. Press the manifold. 3. Attach to rail by pushing on coil area. 2. Align connectors. 1. Hook on rail. Use caution to the bushes for junction not to fall. Caution 1.Be sure to shut off the power and air supplies before disassembly. Furthermore, since air may remain inside the actuator, piping and manifold, confirm that the air is completely exhausted before performing any work. 2.When disassembly and assembly are performed, air leakage may result if connections between blocks and tightening of the end block’s holding screw, is inadequate. Before supplying air, confirm that there are no gaps, etc. between blocks, and that manifold blocks are securely fastened to the DIN rail. Then supply air and confirm that there is no air leakage before operating. 3.Note that for manifolds specified with other than double wiring, spare receptacle housings for expansion are not included unless indicated at the time of order. (5) While pressing the manifold together from both sides, refasten the side U end block’s DIN rail holding screw. Caution (Tightening torque: 1.4 N・m) Caution In addition to solenoid valves, housing holders (SX3000-113-1) are necessary for expansion of manifold stations. Plug-in Manifold Station Expansion �� Double wiring specifications manifolds which do not have the maximum number of stations, contain spare receptacle housings for expansion in the housing holder of the last station, or inside the supply/exhaust block assembly (for a maximum of 2 stations). When expanding stations, perform the disassembly and assembly of the manifold while referring to the expansion method shown below. End block SUP/EXH block Contains receptacle housings for expansion Receptacle housing Housing holder (SX3000-113-1) U side D side 773 Cassette Type Manifold Series SZ3000 SY SJ SY SV SYJ SZ VF VP4 S0700 VQ VQ4 VQ5 VQC VQC4 VQZ SQ VFS VFR VQ7