SV1000 VVQ1000-50A-C3 VVQ1000-50A-C4 VVQ1000-50A-C6 . . . VVQ1000-50A-N1 VVQ1000-50A-N3 VVQ1000-50A-N7 . . . . VVQ1000-51A-C8 . . VVQ1000-51A-N9 . . SV2000 . VVQ1000-51A-C4 VVQ1000-51A-C6 VVQ1000-51A-C8 . . . VVQ1000-51A-N3 VVQ1000-51A-N7 VVQ1000-51A-N9 . . . . VVQ2000-51A-C10 . . VVQ2000-51A-N11 . SV3000 . . VVQ2000-51A-C6 VVQ2000-51A-C8 VVQ2000-51A-C10 . . . VVQ2000-51A-N7 VVQ2000-51A-N9 VVQ2000-51A-N11 . . . . VVQ4000-50B-C12 . VVQ4000-50B-N11 . SV4000 . . . VVQ4000-50B-C8 VVQ4000-50B-C10 VVQ4000-50B-C12 . . . VVQ4000-50B-N9 VVQ4000-50B-N11 SY9000-58A-02�ｭ SY9000-58A-03�ｭ . . VVQ4000-50B-C12 . VVQ4000-50B-N11 SY9000-58B-03�ｭ D Type 10: Tie-rod Base Manifold How to increase manifold bases (Type 10) (1) Loosen the U side screws , and remove the SUP/EXH end block assembly w. Connect the manifold assembly q and supply/exhaust end block assembly w to be added, and tighten the screws . (3) Screw in the tie-rods !4 for station addition. (Screw them in until there is no gap between the tie-rods.) (2) Tightening torques SV1000, SV2000 0.6 N・m SV3000 1.4 N・m SV4000 2.9 N・m Note) When eliminating manifold stations, the appropriate tie-rods !3 for the desired change should be ordered separately. (When equipped with a DIN rail, be sure to tighten the DIN rail holding screws after tightening the tension bolts.) Caution Tie-rod for station addition Fitting Assembly Replacement Caution By replacing manifold fitting assemblies, it is possible to change the size of the A, B ports and P, E ports. To replace them, remove the clip with a flat head screwdriver, etc., and pull out the fitting assembly. Mount the new fitting assembly by inserting it and then replacing the clip to its fully inserted position. Fitting Assembly Part No. Port size P, E Port A, B Port One-touch fitting for o3.2 One-touch fitting for o4 One-touch fitting for o6 One-touch fitting for o8 One-touch fitting for o10 One-touch fitting for o12 One-touch fitting for o1/8" One-touch fitting for o5/32" One-touch fitting for o1/4" One-touch fitting for o5/16" One-touch fitting for o3/8" 1/4 threaded type port block assembly 3/8 threaded type port block assembly One-touch fitting for o8 One-touch fitting for o10 One-touch fitting for o12 One-touch fitting for o5/16" One-touch fitting for o3/8" 3/8 threaded type port block assembly Series SV 630